Posted by Daryl Long on October 14, 2011 at 16:15:46 from (174.60.19.180):
In Reply to: Re: Feeder prices ? posted by Daryl Long on October 14, 2011 at 15:52:18:
Should have posted this one!!!
New Holland, PA Fri Oct 07, 2011 USDA-PA Dept of Ag Market News
New Holland Sales Stables Special Feeder Sale Auction Report for Friday, October 7, 2011
Receipts: 439
Compared to last month's sale, a much heavier run of feeder cattle sold very firm. A large buyer turnout and favorable weather conditions promoted more active buyer participation with good demand. A more attractive supply was also noted. Today s supply consisted of 53 percent feeder steers, 34 percent feeder heifers, and 12 percent feeder bulls. All prices per cwt.
** Attention: Next Feeder Sale will be Friday November 4, 2011 6:00 Pm**
Feeder Cattle:
Feeder Steers: Medium and Large 1 300-400 lbs 126.00-134.00 400-500 lbs 121.00-136.00 500-600 lbs 124.00-134.00 600-700 lbs 130.00-137.00 700-800 lbs 121.00-130.00 800-900 lbs 110.00-122.00
Medium and Large 2 300-400 lbs 110.00-120.00 400-500 lbs 100.00-114.00 600-700 lbs 113.00-122.00
Feeder Heifers: Medium and Large 1 400-500 lbs 94.00-108.00 750-850 lbs 104.00-106.50 Medium and Large 2 300-400 lbs 88.00-98.00 400-500 lbs 82.00-93.00 500-600 lbs 86.00-92.00 600-700 lbs 80.00-90.00
Feeder Bulls: Medium and Large 1 300-400 lbs 122.00-124.00 400-500 lbs 116.00-122.00 500-600 lbs 112.00-118.00
Source: USDA Dept of Ag Market News, New Holland-Lancaster County, PA
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
