Posted by Cal Innes on October 13, 2011 at 15:15:35 from (75.251.47.176):
In Reply to: corn shellers posted by Cal Innes on October 13, 2011 at 09:38:02:
To answer some of the questions posted.... I was thinking of shelling corn but also making the cob meal as well. I considered running a wire the 1/4 mile down the road so I could run a 110 volt charger but I'd have to cross the neighbors land and the road too. (no culverts to run it through and I suspect I wouldn't be popular for running it on the phone poles.) I suppose I could set my own poles.... if they were high enough to permit log trucks to pass safely. As to the question of coyotes eating the corn.... they are Omniverous, eating berries, apples,carrion, mammals,...pretty much anything slow enough to catch. The corn field is full of coyote droppings and, among other things, it has a lot of corn in it. They also leave footprints on corn and cornstalks they have taken down. I have trapped coons for years and if they are there, I'll get 'em and have set coon traps too but no takers this year. Last question was concerning the cobs in the outhouse... I never did use them. We always had a good supply of the Sears&Roebuck catalog. Since they don't put out a good catalog any longer, I have begun subscribing to the Bangor Daily News. Cal
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
