Posted by JDseller on October 09, 2011 at 13:33:27 from (208.126.196.144):
I have two different plumbing projects coming up this winter: remodel on my son's old farm house, and new install on an upstairs bathroom in my house.
I used PEX on a rental house about six years ago. Within two years I had leaks all over the place. I used the brass fittings and crimps to install it. I finally replaced all of the plumbing with copper and was done with it.
I have not used PEX since. The issue has become cost. Copper pipe has gone sky high. 3/4 x 10 foot pipe is $27.75 each. On the Son's house it will cost $2000 dollars more to use copper. Also on the bathroom in my house there is an old unused heat duct that I could run PEX to the upstairs easily. The cost of the pipe in this case is secondary to installation ease.
On line I find older reports and reviews on PEX but not much in the last few years. What kind of results have you had with PEX plumbing lately.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
