Posted by JR FRYE on October 04, 2011 at 10:06:04 from (71.7.54.104):
WHAT’S UP GUYS:
I have been asked to fix this, All he wants it to wield the top like it was done before; I have told the owner that the reason it did not work the first time is because there is way to much stress in that one area, and it will never hold.
I told him he would be better off to replace the spindle and the steering arm and do it right. His answer was how much I replied depending where you get your parts Will depend on how much it will cost: I told him if you buy new parts, the will cost about $450.00 to $600.00. He just about sh-t a new tractor then I told him that was for parts ONLY now the labor Thin I told him the lab, would be about $100.00.
Then he said: NO NEW PARTS: JUST FIX IT ,So I ok: This is my plan tell me if it will work: I will take off the steering arm, Square the wheel up , Drill a hole in the side of the steering arm ½ or 3/8th put the arm back on mark the spindle shaft drill a ½ or 3/8th hole about ¼ ‘’ deep in the steering arm and then tap out the hole in the steering arm for that Bolt size that I use and make a set screw for it: Will this work, If not what will: MANY THANKS GUYS JR FRYE
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
