Posted by Wesley Stephens on September 28, 2011 at 20:26:19 from (75.201.60.53):
A puzzling thing happened today after pulling out a stuck truck. I got our 67 F-600 stuck in some sand and we pulled it out backwards with the rear end in high range and backed it up a few feet after it was out. I didn't shift the axle. When I went to move it forward, the driveshaft would turn but the rear end wouldn't. It didn't make that clicking sound that axles sometimes make on an incomplete shift. After moving the switch a few times and letting off the clutch a few times with it in gear and running, I heard the relay click under the dash and it went into low range fine. I drove it a few miles home, shifting the axle a couple of times and it worked flawlessly.(i usually only shift to low when stopped and shift to high range once I am up to about 40mph in high gear.) Coming up the driveway, I attempted to shift from low to high and got the same neutral position. Again, no noise from the axle. Moving the switch did not result in the noise from the relay and the rear end is not in either range. Does anyone have any ideas other than an electrical problem? I am having trouble finding a wiring diagram or a diagram of the rear end. BTW, I just replaced the splitter button. Any help would be most graciously appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
