Posted by dave2 on September 26, 2011 at 03:33:06 from (79.240.153.233):
here we go....
Got a useless basement under the barn. useless I say because it gets a little ground water in and the humidity when closed (necessary to keep temps above freezing in wither) is 80-100% and potatoes/carrots which are the only 2 things I tried to store, rot ion a couple weeks).
However, It's easy access with only a few steps and a wide door and that door is about 8ft from the barn door. Barn is used as a garage when I need to work on something out of the weather.
Also have a workshop the same size as the cellar that is OK to get to but a PITA to get things in/out if they are heavy/bulky but at ground level and temps/moisture match environment.
Now the brainstorm.....
Could use the workshop space for an addition to another room which is pretty much a junk room (workshop is an even worse junkroom at the moment) as a nice addition to the house since it's connected and only needs a door installed.
Was thinking to smooth the floor in the cellar with a little gravel (enough to go an inch above existing drain in wall at floor level), put down a sheet of plastic, then some crushed limestone/ gravel on top for a floor. Then use this as a workshop because I could then put in vents to control humidity and use a propane radiant heater when I am there and need some heat.
Advice now, what is the highest humidity that I could afford to keep from ruining tools, wooden workbench, etc, etc????
Next advice concerns fruit/veggie storing.......
Piece that I'm calling a workshop now has one end that is 2/3 under ground. Thinking about a wall/door to make a root/fruit cellar to store potatoes, carrots, some apples and pears. What temp/humidity do I need to maintain?
Thanks for any help.
Dave
This post was edited by dave2 at 03:34:04 09/26/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
