Posted by pete 23 on September 23, 2011 at 10:36:31 from (74.32.234.149):
In Reply to: Oh, And Another Thing posted by Allan In NE on September 23, 2011 at 04:09:23:
When IH came with those seals they issued a valve guide machining tool to retrofit old style intake valve guide. It had a stop on it for the correct height and worked well. The new intake valve guide was already machined and the correct length. You don't use the little rubber rings that come in the set though. The good pc style seal goes on intake and unbrella on exhaust. They did a real good job. Before IH got their act together I used to install a lot of the teflon pc seals that worked very well also but were more expensive. I have seen a lot of intake valve seals put on guides that were not machined properly and they do not do a good job. There was an excellent bulletin with all the information but I don't have one anymore. Just go by memory.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
