Posted by jackinok on September 23, 2011 at 07:43:48 from (162.58.82.136):
In Reply to: Re: Skunks posted by Goose on September 22, 2011 at 19:08:00:
civit cats are much harder to trap than a regular skunk.a plain old striped skunk will step in a leghold trap laying out in the middle of a concrete parking lot,but you better have a good set to catch a civet cat.I dont think a striped skunk sees too well,thats why you see them and they will walk right past you if you stand still and never even notice you. a civit cat wont,its almost completly nocturnal,and hunts like a cat.they will climb trees and things to get birds and eggs,where a regular skunk usually wont,and where a regular skunk will kill 3 or 4 chickens in a pen,a civet cat(spotted skunk) will kill them all ,doesnt matter if there are 30 in the pen.think of a cross between a weasel and a striped skunk with 10 times as potent spray and you got a civet cat or spotted skunk.the last ones i saw around here must have been around the mid eighties, they seem to go in cycles for some reason.could have something to do with the number of owls and things around is all i can figure.since they are maybe half the size of a regular skunk owls probably get quite a few of them.most folks when i was a kid would leave their barn loft doors open for the owls to roost in their barns which helped keep skunk,civet cat, and rats numbers down.of course they would get a chicken or duck everynow and then also,but that was considered a small price to pay for the good they did.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
