If it"s a 4 cylinder model, it"s based on a 10/60, or possibly a Leyland (depends on its age). I"d guess that it is an early JCB (inventor of the tractor backhoe)... they bought skid units from Nuffield and mounted their own loader and backhoe onto them. The tractor itself doesn"t weigh more than 5000lbs, but add the backhoe and loader and you might be looking at close to 11000lbs... depends how heavy they built it.
JCB 2 (1964-1967)
� Smaller version of the JCB 3. � Fordson 53.7hp or 55 hp BLMC engines, both three cylinder engines. � Had a small cab and backhoe. � The backhoe had an underslung actuator. � The maximum dig depth was 10ft and it had a maximum load over height of 9ft 10in. � In 1964 a three cylinder Nuffield skid unit was offered instead of the Fordson unit, due to Ford stopping their supply. � A loader only version was developed, called the 2L; it had a counter weight and tow bar in place of the excavator arm. � Weight 5030 kg
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
