Posted by Stephen Newell on September 21, 2011 at 10:30:32 from (66.248.23.149):
In Reply to: o/t U-joint question posted by cbergan on September 19, 2011 at 18:39:38:
I�m not familiar with your vehicle but I have a jeep that I bought a U-joint for that you couldn�t grease. I packed it with grease and that was the last it got. Consequently it didn�t last too long. I purchased another U-Joint from another supplier and the casting on the U-Joint was the same but the grease fitting was on a 45o angle instead of straight like the other one. I�m now able to grease the U-Joint because of the different fitting. They make these aftermarket parts fit so many different vehicles that sometimes they don�t completely work. Perhaps you can purchase a grease fitting on a 45 or 90o angle that will fit in there and not bind.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Winterizin Engines - To Drain or Not to Drain? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "Winter is fast approaching..for a gas tractor should the gas tank be drained and run the engine til the carb is dry or do the gas stabilizer products I've heard of work? (tractor will not be used til spring) any other tips for winterizing?? "
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
