Posted by Greg1959 on September 19, 2011 at 09:59:47 from (69.176.13.178):
Just completed a rebuild of a 1957 ford 800 series 172 c.i.d. engine. Installed it on the tractor. I have heard tales of people doing a rebuild and starting the engine and running it while not checking the oil pressure. Then the engine locks up. I do not want this to happen...so I am taking my time. Anyway, No fuel is going to the motor. I am just cranking the engine using the starter. Would this keep me from building up oil pressure? I don't crank too long but the oil pressure gauge does not even budge. I had some old timers tell me that you have to 'prime' the oil pump before starting, after a rebuild. They could not tell me how to 'prime' the oil pump though. Any suggestions? Or should I go ahead and start the engine and keep an eye on the oil pressure and see if it builds?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
