Posted by doug in illinois on September 18, 2011 at 15:53:23 from (173.233.168.105):
In Reply to: Oil brand used poll... posted by SMHimrod on September 17, 2011 at 20:38:24:
Well, I have been a AMSOIL dealer since 1972 so used to use it a lot.
Now I prefer using Rotella 15-40 in the diesels, and Castrol Syntec in the cars. Oil isn't all you need, a good filter is a must.
I won't tell you what to avoid, but instead will list my preferred filters.
Hastings is my favorite, especially the dual flow filter. Perfect combo to go well over 15K miles between changes on a car that gets driven a lot, like my mail route car.
Wix is more readily available, and less money. I trust them to at least 10K miles.
Fram, Bosch, and all the rest are still good filters that will work just fine with a 3K oil and filter change.
I use OEM filters on my IH1066, meaning Case-IH or at least Fleetguard. No aftermarket filters on it. DOUG
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.