The most common ones now are T-5 and T-8's. These numbers come from the diameter of the tubes. Flourescent tubes are measured in 1/8" increments, so a T-5 is 5/8" diameter, T-8 is 1". If you have a electrical supply house in your area (I mean a actual supply house where contractors go, not Homedepot,lowes,menards)go talk to them. Give them your shop specs (size, height, interior wall surface type) and they will give you a layout of how many of what type fixture will work best. May be t8's or t5's.....just depends. I like the T5's myself. IF you do put them in your shop, I suggest getting ones with a lense. This helps keep the dust out of the reflector. IF your reflectors get dirty, the light output will drop dramatically, but it will be over time so you wont notice. Also, order clear plexiglass reflectors, the prismatic ones also cut down on light emmitance. Also, make sure they give you the highest color rendering number avaliabale. Dont know what the latest/hightest is off top of my head, but this is important also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
