Posted by RedRoundhead on September 07, 2011 at 18:03:32 from (184.230.230.198):
In Reply to: Can I JB Weld this? posted by Crazy Red Power in SE-WI on September 07, 2011 at 15:41:17:
No JB Weld on that, but I would weld it. Is it a 3 piece castnting? Looks like it comes apart. Anyway, I have had alot of luck using UTP Econocast Cast Iron rod. I have filled in stripped sections of gears/sprockets, re-hobbed them, and are still using them today. I also have varying degrees of results on the whole preheat/weld/keep heated/ cool slowly practice of cast iron welding. Sometimes it re-cracks, sometimes not. Alot of variables. Sometimes I start welding, cold, and it welds nice. I ALWAYS drill a "stop hole" at the end of the crack to stop the old crack from spreading. I just keep trying until it works.
Best of luck! If all else fails, just wrap it to keep the hot exhaust gasses contained.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
