Posted by Dean on September 05, 2011 at 09:34:27 from (68.46.208.21):
In Reply to: good wiper blades???? posted by dave2 on September 05, 2011 at 09:17:18:
In one of my former lives, I was a warranty analysis engineer for GM. For a while part of my responsibility was wiper blades and arms. In this capacity, I worked closely with engineers from Delco, Anco, Trico, etc.
The best performing wiper blases that you will ever have are the ones that come on new cars (My experience is with GM but I assume that other manufacturers followed similar practice.) becaause the blades must satisy customer expections for the duration of the warranty (6 months for wiper blades).
OEM blades are made from natural rubber because natural rubber produces the best cleaning and anti streaking performance. The natural rubber is impregnated with wax (as are tires) to protect the rubber from oxygenation due mostly to ozone.
Natural rubber blades perform best but are not long lived due to the previously mentioned detioration, which occurs most frequently during extended periods of hot dry sunny weather. For best performance these blades should be changed every 6 months.
Few if any aftermarket blades (including service market blades sold by the OEMs) are made from natural rubber due to cost.
The black residue that you found on the rag is probably oxydized rubber from expensive natural rubber blades. Changing to less expensive blades, which will have wiping elements made of synthetic plastic, will likely result in longer lasting blades at the expense of somewhat reduced wiping and cleaning performance. Your wife will likely not notice the reduced performance but you will notice the longer life.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
