Posted by Janicholson on September 05, 2011 at 08:52:13 from (199.17.6.77):
In Reply to: Balast compensation posted by Welsarth on September 04, 2011 at 23:18:48:
A great question. Ballasting to limit depth change oscillations might be difficult. I would argue for a more direct solution that allowed stronger traction equalization. That is to use a gauge wheel on the rear plow to force the depth to remain constant. (could be front as well, or only) Plow shares address the soil with a cutting edge. as it wears, the suction of the moldboard changes. Soil conditions (even across the distance between front and rear can also affect the depth and suction across the entire unit. Gauge wheels would be set to just graze the undisturbed earth. My rationale is that construction equipment and leveling devices often use depth gauge wheels to stabelize cut settings. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
