Posted by Billy NY on August 23, 2011 at 21:47:34 from (74.67.3.54):
In Reply to: Re: Concrete burn posted by Oldtractorfun on August 23, 2011 at 13:24:28:
I've done and or supervised quite a bit of concrete work in the past, and as with any material, you need to know what you are dealing with, especially safety and is why we have MSDS sheets for most materials.
Concrete is a mix design of composite aggregates, a cementitious material (portland cement) which bonds the aggregate together. Design mixes vary, aggregate materials vary in properties, as per where the aggregate comes from, there is a certain size from each sieve size (screens of ascending sizes), certain percent passing from each, that comprises a particular design mix, to attain a compressive strength, for a particular application, be it a slab or a beam, column, pier, etc. Water is added, in proportion to cementitious material, is referred to as the water/cement ratio and is extremely important to the compressive strength of the design mix, too much or too little of either will cause the material to fail, it has to be per the design mix, design. Once you add water, and lest we not forget any admixtures, such as accelerators, super plasticizers, what have you etc., you do have a chemical reaction of sorts regardless, and if you look at the links I posted above, I think each site I posted, the information describes why concrete is caustic or can be in varying degrees, at least in laymans terms, which is all most need to know about it, including me ! It burns ... handle accordingly, very simple concept LOL !!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
