Posted by Allan In NE on August 23, 2011 at 04:27:41 from (148.66.88.254):
In Reply to: 1990 GMC 3500 question posted by farmer boy on August 22, 2011 at 21:05:08:
Just musings from my feeble old memory.
The tonners and suburbans always were one year behind in production changes; so if it is a 1990 model, think of it as a heavy version of the '89 pickup.
As Bob has said, I recall them being hard on clutches and brakes. Also, seems to me that was about when the ball joints were dealin� them fits up the kazoo too.
Now, just about anything under the sun would �kill a 700-R4� and that�s why they were phased out in the middle eighties. Just a very poorly designed transmission and it took GM clear up until 1991 to finally get the thing somewhat straightened out as the 4L60.
All said and done tho, that small transmission was never put in a one-ton truck; just in the 2500s and half tons. Even then, it needed more cooling capacity and had trouble with the hard parts breaking.
These were the years when the manufacturers� finally found out that the automatics were becoming way more reliable than the standard transmissions/clutches.
Now, if your just pulling a 16� trailer, it will probably handle it just fine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
