Posted by M-MAN on August 18, 2011 at 22:01:30 from (184.39.186.128):
In Reply to: Home AC posted by Dave in Ms on August 18, 2011 at 08:24:27:
Since you stated AC I'm assuming that's what you have. I'm also assuming you have the correct guages and they are zeroed. You have the gas and guages so your gonna charge it reguardless.
Clean the condensor and evaporator coils before you start. Fantastic will work if you don't have coil cleaner. New filter too.
Hook up the guages and charge to 40 degrees or 68.5 psi on the low side and stop. High side temp on the guage should read 20 to 30 degrees above ambient. If it doesn't you have a problem.
A professonal could dial it in to be more effeicent but that's about a close as any HO is gonna get and it will work for you on any AC unit. Good luck and watch out for frostbite when hooking up the high side.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
