Timely topic. Hoping to drill mine in the next year so I've been researching well records of my neighbors. Pretty much all the same:
3 ft of sand, 100 ft of clay then sand and gravel.
Wells all around 120-150 ft deep with static water levels at about 60 ft down.
Test pumping is done at about 75 ft with flows of between 7-12 gpm.
We're in the Michigan "Thumb" area about 2 miles from 20% of the world's fresh water supply (Great Lakes). What's interesting is that farther north of us along the tip of the "Thumb" there are beach-front properties that can't hit water at all by drilling. They've got to truck in potable water. I've seen them run pipes into Lake Huron for their non-drinking use. My FIL bought a Lake Huron home that has a shallow (25'?) well point on the beach itself. It gets the cleanest, best tasting water I've ever had for well water here in Michigan. It's grandfathered in, but illegal to put one in today.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
