I had a new well drilled here six years ago.(Dubuque Co.,Ia.) It is 180 feet deep and they tested it to 50 gal per minute. I don"t have that big of pump but the well driller checked it at that minimum flow.
Now just a few miles north west their wells will be over 1000 feet deep many will be 1500 plus. They have sulfur water near the surface so to get good drinkable water you have to go under it.
I noticed that billion had a plastic casing put in on his well. They offered me a plastic one. I chose a 6 inch diameter 1/2 inch thick steel one instead. I was afraid of the casing getting broken if it was plastic. It was "new" cut off oil well casings. The lengths where any where from twenty to forty feet long. They welded them together as they lowered them into the well hole. Then they sealed the out side with bituminous clay. Cost about $12,000
What is the best casing???? I did have to change the filer every few weeks for the first year. Had a lot of rust in it. The well driller said it would do that and then stop. It seems to have done that. I still seem to get a lot of fine sand in the filter. Wife finds real fine sand in the cloths dryer lint trap. I guess that is from the well water????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
