Posted by showcrop on August 15, 2011 at 09:23:32 from (75.67.231.80):
In Reply to: Lets try this again. posted by scottymudguy on August 14, 2011 at 19:21:33:
Quoting Removed, click Modern View to see I had a well drilled about 10 years ago but I wasn't around to see anything, so when my neighbor had one drilled a couple weeks later by the same company I stopped in to watch a little. One brother operated the rig while the other read the paper. We could see the pipe going down, so we could see that they would have to add a length soon and we were interested in seeing the procedure. Well, the operator stopped the rotation, reversed, and threaded the top off, raised the top way up, swung the magazine in lowered cap on a length of pipe, restarted rotation, swung magazine back out of the way. His brother never looked up from his paper. They had to go down over 400 ft. so it cost my friend most of his savings. But that was OK because a few months later he hit megabucks for 52 million
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
