Posted by Scottymudguy on August 15, 2011 at 08:55:21 from (209.115.232.65):
In Reply to: Lets try this again. posted by Tony in Mass. on August 15, 2011 at 07:38:35:
Tony,
I'm sitting on one right now...4586' deep, drilling ahead.
Been working on the rig since I was 18, 46 now.
Broke out in worms corner, worked my way up to driller over the years. Went to mud school & ran mud for six years, been a company hand for almost 7 years now.....
Should have said I broke out when I was 18 roughnecked a couple years...went in the navy for 8 years & came back to the rigs after I got out, so only 20 years of experince vs 28 the way I made it sound...oops!!
This post was edited by Scottymudguy at 09:45:20 08/15/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
