I have six pole constructed barns. The oldest was built in 1969. It has real creosoted square post and they are still in good shape.
The next building was built in 1978 it had the salt treated post. They where shot I ended up blocking the wall up and cutting the post off above the ground level. Then dug it out and poured a concrete wall to set the building on. It cost just about as much as I could have built a new shed/barn.
The next oldest building was built in 1978 to but later in the year. I had nothing to do with building it. It is on a farm we bought it 1985. The post are salt treated but are in perfect shape. It was built by a local guy. I checked with him and he stated that there are two different densities of treated post. He always bought the heavier ones. The big box stores keep the lighter ones. They will not last.
The other three building all have the laminated post in them. Treated lumber below the ground and standard lumber above grade. They are two different companies both are in fine shape.
If you can get the better post then fine. If not then I would go with the laminated post. They are not hard to build either. I have build several of them to replaced old barn post with. I usually use 3-2 x 6 and stager the joints with the treated lumber. I put glue between them and use 16 penny nails in a framing nailer. I stager the nails in a repeating "Z" shape up the post. They are stronger than a standard 6x6.
I used 3 2x12 to make the twenty foot long hay wagon rails out of. They bow less then the old 6x8 oak wagon rails. You can save money by building your own post. The trusses you will have to price. I have two truss plants with in twenty miles of me. I can buy completed trusses cheaper than I can buy the lumber. I do nail plywood joiners over the stamped steel attachment plates, in any building that get live stock in it. I have seen the stamped steel rust the teeth off of the plate. The truss then fails.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
