Posted by Lew Best on July 20, 2011 at 09:33:27 from (67.142.163.24):
Hey gang
Got a problem that's really baffling me. I drove my Ford 1841 (gas) into the shop to change out it's cable steering set-up to a conventional one. It sat a couple of months & suddenly when I pulled it out the only way it'll run is with the choke pulled mostly out & then only for a short time. I drove it about 60 or so feet to it's "new parking place" & had to fully choke & restart it 3 times.
I've since cleaned out the gas tank, replaced the internal strainer, cleaned out the carb, replaced the manifold (it nad a hole burned in the exhaust portion) replaced the gasket between the carb & intake (I don't know WHY they don't include this with a carb kit or the new manifold), but it still acts exactly the same as it did when I pulled it out of the shop.
I'm thinking vacuum leak but with all new gaskets, etc. it really has me baffled. It is gravity feed so I'm thinking about putting an electric pump on it (fuel to carb seems adequate though) but they do cost about 45 bux these days so would prefer to leave it gravity since it used to run fine that way.
Anyone have a "good trick" for locating vacuum leaks? I'm told that WD40 is re-formulated so just spraying it around (used to cause a speed change when you hit the leak) don't work anymore.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
