Posted by 37chief on July 19, 2011 at 15:38:56 from (70.181.168.186):
While using my falil mower today one of the lift arms broke off from the mower. I was able to chain it up and get it loaded back on the trailer. I brought back my Woods 6 ft rotary mower to finish the job in one of our hotter days here in Calif. I finished mowing and was leaving. The drive way is about 3 inches of Pee gravel. I had to go around a slight curve, and the driveway was up hill to get out. My trailer slipped off into the drive hedge plants. I removed the tractor from the trailer. As I backed the trailer off I backed into a fence, and broke a 2x6 fence rail. I Hooked a chain and pulled the trailer out of the bushes, as I pulled the trailer sideways to clear the bushes the truck rolled back into the same spot, I forget to set the brake. With the trailer on firm ground I backed the truck through the bushes, and tore a rubber part from my front bumper. While doing all this I have a real bad pain in my left side for some reason, been like that for about three days now. Should have stayed in bed. stan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
