Posted by Owen Aaland on July 14, 2011 at 22:48:31 from (216.47.33.237):
In Reply to: 656 Hydro question posted by TimWafer on July 12, 2011 at 07:15:05:
On the left side of the center section of the tractor there are two 1/4" steel lines. Behind the rear one is a large pipe plug with a recessed square hole. remove that plug and the end cap for the shuttle valve is just inside. Remove the end cap carefully because if the snap ring is off or broken there will be some loose parts. Usually all it takes is to install a new snap ring and reassemble.
A more common complaint with the snap ring problem is that the tractor will not go backwards unless you first move the lever forwards or use the Foot-N-Inch valve. When it does go into reverse it does so with a jolt.
If the snap ring is not the problem then you need to isolate the hydro unit from the outside controls by disconnecting the two high pressure lines and cap them. If you do this be sure you have plenty of room around you because the Foot-N-Inch valve will no longer control the tractor. The only control will be the SR (Speed Ratio) lever. That test can determine in the problem is internal or in the outside controls.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
