Posted by PM BAKER on July 05, 2011 at 07:34:59 from (24.110.108.198):
I installed Westwood F100-14 Filter Vacuum Gauge on my MF30B, it normally uses a Donaldson ServiSignal mini indicator that shows a red flag when limit is reached. I installed the gauge because it tells me exactly what is going on 0-30hg, not just a red flag like the Donaldson.
I installed the gage, and new filters. I restricted the air intake pipe with my hand almost airtight, and the gage did not move from zero. I removed it and ran a wire up the connector into the intake air stream where the gage connects to the fitting, to make sure there are no obstructions, there were none. I reconnected the gage, and tried again restricting the intake, and with the engine revd up,the suction on my hand was strong, but the gage registered nothing. I think it's a defective gage. The manufacturer is sending me another.
My question is, am I right in my procedure for testing? How can the engine run if I restrict the air almost totally? It was just for like 10 seconds, but I didn't notice much change. Shouldn't I see black smoke or something?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Perfect Restoration - by Chris Pratt. Often, in quiet moments, I have wandered back in my thouhts to the many tractors I have seen over the years and wondered which one inspired me the most. Sure, we have a fond attachment to one brand and model or another, sometimes it was remembering that first time we got to climb up in the drivers seat and command that roaring beast, or maybe because when you see that special model, you can't help but see Dad on it, he's gone, but everytime you see a tractor like his, it's a like part of him i
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
