Posted by WyoDave on July 01, 2011 at 08:40:20 from (75.244.208.210):
In Reply to: WyoDave posted by Pat-CT on June 30, 2011 at 20:30:18:
These are pictures from last year, but they show how it works for the most part.
The bale loader lifts the individual bales and lays them flat on the first table.
When you get three on the first table it automatically trips and sets the three bales on edge, on the second table.
After 6 sets of 3, the second table automatically trips and places 18 bales on the load rack. There is a rolling rack behind the bales that slides back as the stack is formed.
I put 2 "tie" layers in my stacks which I can form from the cab, as mine has an auto tie function.
Once I get 9 layers on, then tilt the stack up, and place it against my previous stack.
Then push the balewagon out from under the stack. Clear as mud??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.