Posted by Lloyd in South Carolina on June 07, 2011 at 05:24:11 from (162.111.235.14):
In Reply to: pulling dents posted by mark in boonville ny on June 06, 2011 at 20:08:51:
Hi Mark!
There is a studd gun you can buy that spot welds small posts on to the dent area, and then a puller/slide hammer that grabs the posts and you slide hammer them out. And espensive tool if not used alot.
Cheaper solution, buy a body work slide hammer, they have sheet metal screw ends, you drill small holes, screw in the end of the hammer, and slide hammer out the dent. Then the holes are welded up.
Some dent actualy stretch the metal when they occur. Therefore the dented area's metal needs to be shrunk. Usualy done by heating, and quenching with water which shrinks the metal.
The bad news about all this, is you need to be able get to the back side of the work area, to re paint and seal after all this work or you have opened it up to major rusting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
