Taking apart a lever action rifle is tough, so I have read. I have never taken apart a lever action rifle and would think doing a full tear down in a fox hole would be difficult. I dont know what rifle(s) were used in the Spanish American war in the 1890's I have to look up what rifle was standard issue in WW1. In WW2 the main issue rifle was the M1 Garand, A semi-auto rifle that fired a .30 caliber bullet, .30-06 on most I think. And General Patton made the remark "the M1 Garand rifle is the best battle rifle ever made" I may be off a few words there but If Patton liked it then it was better then good. The Jabs and the Nazis had Bolt action rifles in the battle field and we had semi-auto rifles for quick follow up shots. I have also read that a lever action rifle does not give as good of accuracy compared to other rifles due to a 2 piece stock and a thin walled receiver. (so says the NRA firearms sourcebook) I can still hold a group the size of a baseball at 25 yards with open sights with my Winchester while standing. (fun too)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
