Posted by Bernie/MA on May 31, 2011 at 09:30:48 from (159.250.60.47):
In Reply to: 8N Steering Problem posted by BRIFLE243 on May 31, 2011 at 05:45:05:
I just replaced the shaft bearings in my Jubilee. The bottom one in the oil was ok but one above the worm was totally gone, pieces in the bottom of the case. Yours must have bound up instead of falling apart. There's another one just below the steering wheel I freed up before. I got the shaft out of the box by cramping the jacked up wheels while my friend lifted the shaft out. The steering wheel will come off with a 3-jaw puller and a smack with a hammer on the hub. Use small clevises on the spokes so the puller will be in the right direction. HTH.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
