I reset about 2000ft of 5-strand T-posts in 2006. Then again in 2008. I guess it depends on what kind of ground they're drove into. In my case, it was wetland. I didn't fill at all, I just spent most of time pulling all the floatsam and jetsam off the wires after it tried out, then I would walk back and forth along the fence line about 10 posts at a time pushing each post as far as I could and using my boot to push mud in the hole that the post left. Eventually they stand straight again. I wouldn't bother with any type of fill because you know what that's going to amount to during the next flood: absolutely nothing.
If this doesn't seem reasonable in your ground, just wait for a good rain and try it. I do the same thing on my high-ground fences in clay after a rain. They get knocked over by cows reaching for alfalfa in the spring, but posts feel about the same effect as a flood :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.