Posted by Ultradog MN on May 23, 2011 at 17:43:15 from (70.57.151.141):
Someone run him off? I haven't seen him lately. I've been messing with a 3 cyl CAV rotary pump here. I took the 4 bolts out of the back end of it and sprayed it out with brake cleaner. All the ports had been open and I was worried about having junk inside so I sprayed it all out with brake cleaner. I could see the offset vanes inside. Good thing I did as there was crud in there. Afterwards I shot some PB blaster in there to lubricate it and put the cover back on, put the 4 bolts back in and tightened it down. I wonder if those 4 small bolts (5/16 head) should be torqued? The seal there looked fine so I just put it back in. Ok? I could ask a dozen questions about this pump if someone could tell me about them. Or, if I could find some literature about one I would do my own homework. I'm over my head but not scared. Suggestions and advice are welcome. Thanks -
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
