Posted by George Marsh on May 11, 2011 at 12:21:15 from (71.127.17.176):
In Reply to: Cedar siding any good? posted by 2cylpartsinfo on May 10, 2011 at 18:39:36:
I know of a house built in 68 and the south side of the house is a mess. When you cut the wood it smells like you are cutting tar, not cedar. Then someone painted over it with latex a few times. Paint is pealing, cedar has major cracks in the middle of the boards. The wood is ruff cut and ran vertically, 10-12 inches wide. Stripped most of the paint off with 3600 psi along with about 1/16 inch of the wood. I'll have no choice but fill in the major cracks and paint it. Not to steal your post. Does anyone have a solution short of re-siding?
BTY, I would not ever use cedar on a house.
I have a house built in 39 with wood lap siding and could never keep paint on it. Put 20,000 brick on the house 20 years ago and I've never had to do a thing to the siding again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.