Posted by 135 Fan on February 20, 2008 at 15:58:50 from (68.149.51.25):
In Reply to: Re: Hey Puddles? posted by Puddles on February 20, 2008 at 15:38:12:
Thanks Carl. I guess that you'd like people to ctitique your welds as I do? Makes you always try to do the next one better. My original question only asked about what process was used, not about picking it apart. I was asked and so I answered. It's too bad we weren't in your shop together for some show and tell. I'm certain that I would learn a thing or two. You can't take a weld off the internet and use it to hold your project together. Pipe welds are usually the most inspected as they are usually 100% X-Ray. Sometimes you do get overly picky inspectors though. Most of the time they say that if you can't catch your thumb nail on the edge of the weld is perfectly fine. I had an inspector tell me I had undercut once. I took my thumb nail and flicked off a piece of mill scale! That's probably why most guys run a file around the edge. I'm thinking about making an attachment for the 4 in 1 bucket on my Cat, so I can screen out rocks and twigs from a big pile of loam I pushed up. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.