Tool Talk Discussion Board |
Re: Miller 6 pin TIG output remotes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Crem on February 14, 2007 at 21:43:16 from (72.156.122.242):
In Reply to: Miller 6 pin TIG output remotes posted by '52 Farmall H on February 14, 2007 at 18:22:44:
I used to repair a lot of those foot pedals before I retired. I believe that the total resistance is 1000 ohms but can't remember for sure. Are you using the pedal for tig welding? We also used hand controls for that. They are just a box with a slide switch to turn on the contactor and a potentiometer to control the amperage. Be sure to get it wired up right so that you don't burn out a board. I just found a discussion on the resistance values.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|