Tool Talk Discussion Board |
Re: Extreme size welding
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 135 Fan on October 30, 2006 at 18:37:53 from (68.149.51.133):
In Reply to: Re: Extreme size welding posted by paul on October 30, 2006 at 18:22:09:
Everythings good. I meant to say click on the small pictures after you get to the site. I feel like crawling in a vessel. It would be a lot easier than figuring out these darn computers. The welders and boilermakers making these things get pretty good money but it's all relative. Welding used to be one of the higher paying jobs. It still can be but there are people sitting behind a desk twiddling their fingers that are making over 100K a year. The highly skilled and talented trades people that have to do precision work are making less than some pencil pushing geek. I think it is an injustice. These things could kill a lot of people if they failed. Can't say that about someone spelling a word wrong in some bogus report to justify their job. Dave
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|