|
Tool Talk Discussion Board |
Re: cutting with propane
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RusselAZ on January 11, 2004 at 09:46:43 from (67.136.223.53):
In Reply to: cutting with propane posted by jake on January 10, 2004 at 18:05:22:
Remember, you don't cut with the gas that feeds the flame. It is only there to get the metal up to a temp that the oxygen stream can oxidize the metal away. If you have a steady hand you can get a cut started and turn the gas off and keep cutting. I used to work with a guy that could split a 8 ft sheet of 1/2" plate that way. About 2 foot is all I ever made it!. My favorite now is a plasma cutter. cuts ANY metal leaving it cool.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|