Tool Talk Discussion Board |
Re: Alumaloy
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bus Driver on June 10, 2003 at 17:26:26 from (65.165.153.91):
In Reply to: Alumaloy posted by TwinCreek on June 10, 2003 at 07:15:09:
I bought some from a vendor demonstrating at a show. Watched him several times. One of the secrets is to rub the rod hard into the material being repaired even while bringing the heat up to the required level. I think that the rubbing helps break the oxide layer on the aluminum. Also notice that the area is cleaned first with an uncontaminated stainless steel brush. I have been pleased with my results. I think that the rods are mostly zinc content.
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|