|
Antique Tractor Paint and Bodywork |
Re: Re: Re: First paint job , need advise
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on March 04, 2002 at 20:43:57 from (206.152.181.170):
In Reply to: Re: Re: First paint job , need advise posted by Keith B on March 04, 2002 at 07:27:10:
Hi Keith, Thanks for the kind words. Great idea to practice on the implements, especially back blades. They will give you a nice broad vertical surface on which to find out how heavy you can apply without generating runs and sags. Ironically, the expensive urethanes are really a breeze to apply I think...easier than the enamels. One thing you will likely find with both alkyd and acrylic enamels is that you are walking a tightrope between applying it heavy enough to flow out well, avoiding excessive orange peel and getting it on too heavy and winding up with runs and sags. The trick is to get it just right and that takes some practice. Usually for enamels you give it just enough time to get a little tacky between coats. Everybody�s situation is usually a little bit different and what might be best for me may not be best for someone else in a particular circumstance. Certainly $$$ enters into the picture for most people and compromises have to be made. Putting a thousand dollar paint job on a working tractor is not necessary in my opinion for it to look "good". My neighbor down the road a-piece maintains his Cat backhoes and Michigan loaders very nicely with a brush and a few gallons of Cat paint :o). They look good to me. To each his own though. You have realistic, reasonable goals and I am convinced you will make it look good indeed. Have fun and take care. Rod
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|