|
Antique Tractor Paint and Bodywork |
Re: Pressure at gauge at the wall
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on September 30, 2004 at 22:03:27 from (64.140.200.138):
In Reply to: Pressure at gauge at the wall posted by Ray A on September 30, 2004 at 18:21:39:
Hi Ray, The gage reading back at your wall regulator is not relevant. What matters is the pressure right at the gun inlet with the fan pattern adjustment wide open and the trigger pulled. The correct maximum pressure at the gun inlet for your HVLP gun should be specified in the documentation that came with it or actually stamped or otherwise indicated right on the gun handle. This is a maximum pressure that is specified to comply with the HVLP legal requirement for 10 psig maximum at the air cap. Assuming you are bound by local legal requirements or just wish to comply with HVLP transfer efficiency, you should adhere to the maximum pressure specified by your gun manufacturer. That's what the gun and air cap are designed for. Forget the gage back at your wall regulator. Adjust your wall regulator to get the proper pressure as read on the gage at your gun inlet with the trigger pulled. The gage back at the wall regulator will always read higher but the reading is not important. If you have some additional "regulating" device at your gun inlet, can it and replace it with just a teed-in pressure gage. You don't need a regulator on top of a regulator. There are "fine tuning" methods based on actual atomization results (not pressure readings) but I have never found them to be necessary. I set my HVLP gun to the manufacturer's maximum and go with that. For my non-HVLP gun, I set in the high end of the range recommended by the paint manufacturer. Rod
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|