|
Oliver, Cletrac, Co-op & Cockshutt Tractors Discussion Board |
Re: Re: Re: Re: Re: 1855 Gasser
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on December 22, 2002 at 02:42:46 from (195.93.48.13):
In Reply to: Re: Re: Re: Re: 1855 Gasser posted by WFE on December 21, 2002 at 20:25:08:
maybe referred to as electrolysis, but electrolysis indicates electric current passage causing the erosion. Your explanation is mmore similar to pump cavitation - with the same results- where the small cavities are vacuum cavities. All points to the vibration problems in this engine probly caused by the block castings etc. not being stiff enough to easily resist the extra loadings of the high power diesel turbos etc. etc.
Just an observation: Along with all the other design shortfalls its a wonder any of them have refrained from going into orbit! The fact that they didn't must mean that the individual design points were marginal and the 'worst case' scenario (rod out of bed) for any particular engine only happened once, after all!!!
Regards and have a merry Xmas, RAB
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
