Ford 9N, 2N & 8N Discussion Board |
Re: Stump pulling
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave H (NY) on December 19, 2004 at 08:11:26 from (69.201.197.120):
In Reply to: Stump pulling posted by Paul in MD on December 18, 2004 at 12:57:11:
Paul, I have pulled stumps and dug them out, not an easy task reguardless of how you do it, I have cut down roughly 400 trees on my property over the last two years with atleast that many to go, I recently bought a three point backhoe that has greatly helped in stump removal, I dig around them first then just grab them with the bucket at the base and pop them out. In pulling stumps with the tractor as others have said pull from as low as possible on the tractor and 2 or 3 feet up on the stump for leverage keep your foot on the clutch and be careful.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|