Ford 9N, 2N and 8N Discussion Board |
Re: Re: 8N Fan Belt R R
[ View Follow Ups ] [ Post Followup ] [ Return to Ford 9N, 2N and 8N Discussion Board ]
Posted by 8N333X on April 27, 2000 at 16:30:10 from (63.16.59.61):
In Reply to: Re: 8N Fan Belt R R posted by Claus on April 27, 2000 at 16:00:47:
Thanks for the suggestions Claus & Jerry. This old tractor is running just fine right now. There is no problem on removing the old belt off of the generator and then from the fan/water pump pulley. The problem will be in the gland nut or hand crank receptacle. There is too little clearance for a new belt to fit between this crank pulley "nut?" and the front flange that creates the "well" that the crank pulley is in. I will take your advice on the bell size for a replacement. Just as soon as I can figure out how to take this thing apart and put it back together. Any other thouthts? From Wonderful Waxahachie Charles
Follow Ups:
Home
| Forums
Today's Featured Article -
The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|