|
Ford 9N, 2N and 8N Discussion Board |
Re: Re: 8N No Compression
[ View Follow Ups ] [ Post Followup ] [ Return to Ford 9N, 2N and 8N Discussion Board ]
Posted by Barry 1950 8N on April 23, 2000 at 13:35:03 from (209.240.216.83):
In Reply to: Re: 8N No Compression posted by Jerry on April 23, 2000 at 07:19:12:
I would confirm that your cam shaft,timing gear and distributor are all turning and intact. If your not getting any pressure with the finger over spark plug hole test,you may not have timing or compression, due to the above. Been there-Done that!
-Good Luck!
Barry/Vermont
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Trailerin a Tractor, Chains or Straps? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I bought a trailer and plan to take my CASE VAS to some shows. I don't yet have anything to secure it to the trailer. So which is better to buy and use; the ratchet-type straps or binders and binder chains?
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
