Massey Harris & Massey Ferguson Tractors Discussion Board |
101 jr transmission
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 101jr on February 21, 2007 at 18:07:34 from (136.204.208.192):
Hello, I have a 1944 101 jr. My problems is the output shaft going to the ring gear slipped outof where it should be some how. The pinion slipped off the ring gear and now i have to get it back onto the ring gear. It seems that I may have to loosen the forks to get it back up into there because it hits the forks and it needs a little more to get into the hole. My question is- What would cause this and is there anything that holds the output bearing in its place and does it sound like im doing it right? Any help is appreciated
Replies:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|