Massey Harris & Massey Ferguson Tractors Discussion Board |
Re: Proper way to disengage spinning PTO. on 135
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John (UK) on June 24, 2006 at 12:46:28 from (88.109.245.169):
In Reply to: Re: Proper way to disengage spinning PTO. on 135 posted by Old Rake on June 23, 2006 at 17:51:07:
if the tractor is stopped but the PTO is spinning you can"t engage ground drive it will grind because the PTO shaft is turning but the drive pinion into the axle isn"t. But how many use ground drive anyway, not many now. Regarding changing gear, MF advise you not to change gear on the move, before you jump up and down about that, you will agree that without some expertise in changing on the move it could cause a lot of damage in the wrong hands. Most people change on the move, it does take some practice to do it though without crashing the box.
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|