Massey Harris & Massey Ferguson Tractors Discussion Board |
Re: Proper way to disengage spinning PTO. on 135
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on June 22, 2006 at 23:09:51 from (64.12.116.201):
In Reply to: Proper way to disengage spinning PTO. on 135 posted by 02 on June 22, 2006 at 19:23:23:
By your description it's gotta be a 2 stage clutch, which all that I know of are just that. I see no problem disengaging a 2 stage pto while holding in the clutch. Were it our 285 that is hyraulic, yeah you gotta idle it down before you disengage it, atleat if it's a brush hog or a forage blower without a ORC in the drive line. We've had the PTO clutch replaced twice in it. Once was after having to run the blower for a few years, it just took it out having to stop that inertia, even from an idle. Now the 1600 Oliver is back in it's place on the blower, no prblems with that one.
Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|