Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
John Deere Tractors Discussion Board

Re: carb adjustment for M


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by clooney on November 21, 2000 at 09:37:35 from (207.16.59.231):

In Reply to: carb adjustment for M posted by Duane on November 21, 2000 at 04:45:36:

Duane, I presume it's a TSX-245 carb? If so then adjust the idle needle (with the engine warm & the engine at slow idle) until the engine idles evenly (in warm weather that should be from 1-1/2 to 1-3/4 turns out from seated. Adjust the load needle (note: it must be under a belt,PTO or other load to make the carb go to the wide open position'''just holding it wide open won't work) by turning it in until the engine looses power then back it out until the engine begins to run evenly, then 1/2 turn farther open. I know this will be difficult so you can get close by turning the load needle in until it won't pull good going up a hill then out until it just starts to pull good going up a hill then 1/2 turn more. Leaking throttle shaft seals/bushings, dirty carb, poor ignition timing, plugged air cleaner, bad spark plugs/wires, or worn engine will change or make these adjustments difficult or different.


Follow Ups:




Post A Followup

:
:

: Re: Re: carb adjustment for M

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums  |  Order Support


Today's Featured Article - Restoration Story: Field Marshall Series 1 - by Anthony West. I had been restoring tractors for several years, and over that time had aquired a varied collection of machines of all ilk. I had started on Fordsons both standard and major, and from there progressed as my skills and knowledge increased. It had always been my ambition to own one of the rare types of tractor. The sort of machine that was eagerly talked about at meetings and gloated over lovingly at shows. One such machine was Field Marshall, I had heard many men talk of this machine with a p ... [Read Article]

Latest Ad: John Deere 750 Diesel Yanmar J80TU engine. pistons and rings replaced when discovered crankshaft was bent. 3995 OBO Pictures available upon request [More Ads]

Copyright © 1997-2026 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy